DU BI CHEM MARINE INTERNATIONAL is leading one Largest Manufacturer, Exporter, Distributor , Supplier of VOLC white Multi Clean in Fujairah UAE, Dibba Port , Jabel al Harim, Dibba Al, Khasab, Kalba , Al Qusais, Deira, Saif Zone, Sharjah ,Dubai, Abudhabi, Ajman, Diera, UAE Middle East, Al Quoz, Jebel Ali, Umm Al Quwain, Ras Al Khaimah, Masafi, Khor Fakkan, Al Hayl, Al Ain, Ras Al Khor Industrial Area, Al khubaisi, Umm Ramool Industrial Area, Al Qusais Industrial Area, Jebel Ali.
Product Information:
VOLC white Multi Clean :RXSOL-10-1083-025
A concentrated oil and grease solvent and emulsifier. Penetrates, dissolves and flushes away dirt , temporary coatings from metal and painted surfaces as well as wax, dirt, oils, greases from machinery, floors and equipment. Emulsion Degreaser will not flash ignite below its boiling point (210 degrees F.) and is self extinguishing.
Its POLYMER formulation provides multi metal corrosion protection for 24-48 hours
Product Application:
- Biodegradable, Heavy-duty temporary coating, grease and sludge remover
- Effective cleaner for for light oils and greases
- No reaction with painted surfaces, Non-flammable
- High Viscous liquid that will cling to ceilings and vertical surfaces in a ready-to-use formulation
- Dilution ratio up to 0.5% also gives good results for cleaning.
- Its Polymer based formulation gives corrosion protection on cleaned metal parts
Using Procedure:
Spray or mop Emulsion Degreaser over surface to be cleaned. If grease buildup is thick, score with a wire brush and mix with cleaner. Allow Emulsion Degreaser to stand for 10 minutes then hose off with water, preferably a pressure washer type system. Emulsion Degreaser can be used as a presoak or pretreat prior to cleaning with steam. For milder soils Emulsion Degreaser can be diluted with 10 parts of water. This dilution can be used in tanks or for swabbing off surfaces. Emulsion Degreaser can be used safely on ferrous metals and is excellent for degreasing concrete floors prior to painting. It can also be used on engine blocks, chassis, machinery and shop floors.
INDUSTRIAL CLEANING :
1st step ::: Apply full strength or diluted ( 40 part water and 60 PART RXSOL ) It can be sprayed with an airless, pot agricultural sprayer. Always test wet film coverage on a neutral surface before beginning. Let the product stand (wet) for 2-6 minutes, depending on the film thickness of the product to be removed and the length of time that the coating has cured. Reapplication may be required.
2nd step ::: For Removal of product and coating ::: use POWER WASHER with Pressure: 50-300 psi (3.4-21 bar) Temperature: 115o-160oF (46o-71oC)
If the coating is not removed completely repeat step 1.
3rd STEP :::
For Cleaning Engine Blocks or Heavily Greased/Soiled Equipment:
1. Repeat step 1 above. The solution may be diluted to increase penetration. Let the product sit for 5-20 minutes.
2. Repeat step 2 above.
3. Repeat process as necessary until greased/soiled equipment is clean.
Product Note:
Material Safety
Avoid contact with skin and eyes. For contact with skin, flush with water. For contact with eyes, flush with water for 15 minutes and seek medical attention. If swallowed, drink two glasses of water and induce vomiting. Seek immediate medical attention. After vomiting, give water, milk or solution of sodium dichromate in water (1 teaspoon per quart). Do not give anything to an unconscious or convulsing person. Caution, contains heavy aromatic naphtha.
Product Technical Specification:
Appearance
White Viscous
Density
> 1
Odor
Sweet Smell
Flash Point
None To Boiling Point
Solubility
Excellent
pH Level
Neutral
Foaming
Low
Stability
Stable
Available Packing Size: 25 Ltr.
DU BI CHEM MARINE INTERNATIONAL offers highest quality products in Tank cleaning, Drilling Fluid Chemicals, Hold Solution, Agriculture, Lab Chemicals, Raw Chemicals, Sewage Chemicals, Detergent, Degreaser & Floor care chemical.Our in house lab and QC department is strong in equipment, knowledge and system to meet the international standards. We produce a superior range of VOLC white Multi Clean with advanced manufacturing technology and using superior quality raw materials. We assure quality and ensure that only the best is catered to the customers.Our basic motto of the company is to give a better product to the customer at the lowest rate. We are keeping a ready stock of VOLC white Multi Clean , for any support and price, Feel free to contact us through our Email id dubichem@gmail.com
We are presently operative in all over India and you can buy our products from various locations Like Andhra Pradesh, Tamilnadu, Gujarat , West Bengal and also all seaports of India. We do have many satisfied customers in this Industries because of our QUALITY, PRICING & SERVICE. Our Company is also a Major Exporter & Mfg of VOLC white Multi Clean in UAE, Oman , Vietnam, Europe, Africa, Bahrain, Qatar, Africa & many more countries.
Supply Locations :
Dubai, Oman, Bahrain, Abu Dhabi, Ajman, Al Ain, Dubai, Ras Al-Khaimah, Ras al Khaimah, Fujairah, Sharjah, Umm Al Quwain, Fujairah, Ruwais, Mina (Port) Zayed, Khalifa Port, Kizad, Port Rashid, Jebel Ali Port, DP WORLD, Jebel Ali Free Zone, Khor Fakkan Container Terminal, Port Rashid, Jebel Ali Port, Mina Kalid Port, Khor Fhakan Port ( Khawr Fakkan, Khawr al-Fakkan ), Sharjah Creek, Ajman, Port of Hamriyah, Mina Zayed Port, Mussafah port, Khalifa Port, Umm al-Nar Port, Um Al Quwain Port, Saqr Port, Port of Fujairah, Dibba Port, Jebel Dhanna, Mina Al Hamriya, Mina Rashid, All United Arab Emirates.
