DU BI CHEM MARINE INTERNATIONAL is leading one Largest Manufacturer, Exporter, Distributor , Supplier of Activated Alumina Desiccants in Fujairah UAE, Dibba Port, Jabel al Harim, Dibba Al, Khasab, Kalba , Al Qusais, Deira, Saif Zone, Sharjah ,Dubai, Abudhabi, Ajman, Diera, UAE Middle East, Al Quoz, Jebel Ali, Umm Al Quwain, Ras Al Khaimah, Masafi, Khor Fakkan, Al Hayl, Al Ain, Ras Al Khor Industrial Area, Al khubaisi, Umm Ramool Industrial Area, Al Qusais Industrial Area, Jebel Ali.
Product Information:
Activated Alumina Desiccants : RXSOL-19-1905-025
Activated alumina is an excellent desiccant for drying a wide variety of liquids and gases. Our activated alumina has been developed with high attrition resistance and crush strength, It has larger water adsorption capacity compared to molecular sieve at high relative humidity and provides long service life with performance at or below dew point specifications.
Activated alumina is highly porous material; this material can have a surface area significantly over 200 square metres/g. Very suitable for use as a filter of fluoride, arsenic and selenium in drinking water.
Activated Alumina is an aluminium oxide that is highly porous and exhibits tremendous surface area. Activated Alumina is resistant to thermal stock and abrasion and will not shrink, swell, soften nor disintegrate when immersed in water.
Surface area is in the range 345-415. Because it has a higher capacity for water than Silica Gel at elevated temperatures it is mainly used as a desiccant for warm gases including air. In many commercial applications zeolitic materials have now replaced it.
Product Application:
Purification of gases and liquids (removal of metallic traces, TBC and HF compounds).
Drying of organic liquids such as LPG, propylene, butene, steam cracked liquids, cyclohexane, gasoline, chloro- and fluoro hydrocarbons, aromatic solvents.
Drying of air and gases such as steam cracked gases, catalytic reforming recycle gas, synthesis gas, natural gas, CO2.
Drying of organic liquids as LPG, aromatics, steam cracked liquids, gasoline, chloro- and fluorocarbons.
Drying of air and gases as steam cracked gases, catalytic reforming recycle gases, synthesis gases, methyl chloride, natural gas, LNG, etc.
Drying of hydrogen, oxygen, nitrogen, CO2, etc.
Purification of gases and liquids (removal of metallic traces, BF3, TBC, HCl, HF and fluorinated hydrocarbons).
Catalyst for Claus conversion in sub dew point processes.
Air drying (PSA, TSA)
Instrument air, supersonic wind tunnel, compressed air
Gas drying Air separation plants, inert and rare gases, Hydrogen, oxygen, nitrogen, CO2.
Natural gas in production and compression plants, LPG, LNG.
Aromatics, naphtha cuts and cracked gas.
Activated Alumina Desiccants is a porous form of aluminum oxide. It has a high surface area which adsorbs vapors without any change in form. Activated Alumina Desiccants will not soften or disintegrate easily when immersed in water.
Dew points to -40°F and lower may be achieved with Activated Alumina Desiccants depending on dryer design and operating conditions.
The 1/8 (2-5mm) bead is the size most frequently used in regenerative dryers.
The 3/16 (4-8mm) bead is used when pressure drop and surface area requirements fall between 1/8 and 1/4 material. It is suitable for most systems.
The 1/4 (5-10mm) bead Activated Alumina Desiccants is used both as a pre-bed material to support large desiccant beds or as a buffer for silica gel beads. Pressure drop is slightly lower than 1/8 (25mm) material.
If size is not known or specified, the 1/8 (2-5mm) size is usually satisfactory. However, if Activated Alumina Desiccants is used in a regenerative dryer and the desiccant retaining screens cannot be measured, the 1/4 (5-10mm) size should be used as a bed support (6 layer). If at all possible, obtain a sample and measure it before ordering.
Product Benefits:
High adsorption capacity. With high surface area and excellent pore distribution, Activated Alumina Desiccants has a high water adsorption capacity. This reduces initial cost, energy consumption and operating costs through smaller bed sizes and/or longer operating cycles.
Low abrasion. Ensures less dusting during tower depressurization or loading. Low abrasion means low pressure drop and a reduced chance of plugging the afterfilter.
Resists liquid water. Water slugging due to upstream failure of aftercooler, separators or drain traps will not fracture the alumina beads. The adsorption capacity of the desiccant can be restored after complete regeneration.
High crush strength. High crush strength, which limits dusting, is important during loading of desiccant towers. High crush strength makes alumina effective as a pre bed material when used with other types of desiccants.
Uniform bead sizes. Activated Alumina Desiccants is a uniformly sized bead. It provides low pressure drop to minimize channeling and ensures utilization of the full bed column section.
Product Note:
Potassium Permanganate Impregnated Alumina has strong oxidizing property with Potassium Permanganate (KMnO4), it has good efficiency in removing Hydrogen Sulfide(H2S) , Chlorine(Cl2), Formaldehyde(HCHO), Nitric Oxide (NO) & Sulfur Dioxide(SO2) from air.
Product Technical Specification:
Available Packing Size: 25 Kg.
DU BI CHEM MARINE INTERNATIONAL offers highest quality products in Tank cleaning, Drilling Fluid Chemicals, Hold Solution, Agriculture, Lab Chemicals, Raw Chemicals, Sewage Chemicals, Detergent, Degreaser & Floor care chemical.Our in house lab and QC department is strong in equipment, knowledge and system to meet the international standards. We produce a superior range of Activated Alumina Desiccants with advanced manufacturing technology and using superior quality raw materials. We assure quality and ensure that only the best is catered to the customers.Our basic motto of the company is to give a better product to the customer at the lowest rate. We are keeping a ready stock of Activated Alumina Desiccants , for any support and price, Feel free to contact us through our Email id dubichem@gmail.com
We are presently operative in all over India and you can buy our products from various locations Like Andhra Pradesh, Tamilnadu, Gujarat , West Bengal and also all seaports of India. We do have many satisfied customers in this Industries because of our QUALITY, PRICING & SERVICE. Our Company is also a Major Exporter & Mfg of Activated Alumina Desiccants in UAE, Oman , Vietnam, Europe, Africa, Bahrain, Qatar, Africa & many more countries.
Supply Locations :
Dubai, Oman, Bahrain, Abu Dhabi, Ajman, Al Ain, Dubai, Ras Al-Khaimah, Ras al Khaimah, Fujairah, Sharjah, Umm Al Quwain, Fujairah, Ruwais, Mina (Port) Zayed, Khalifa Port, Kizad, Port Rashid, Jebel Ali Port, DP WORLD, Jebel Ali Free Zone, Khor Fakkan Container Terminal, Port Rashid, Jebel Ali Port, Mina Kalid Port, Khor Fhakan Port ( Khawr Fakkan, Khawr al-Fakkan ), Sharjah Creek, Ajman, Port of Hamriyah, Mina Zayed Port, Mussafah port, Khalifa Port, Umm al-Nar Port, Um Al Quwain Port, Saqr Port, Port of Fujairah, Dibba Port, Jebel Dhanna, Mina Al Hamriya, Mina Rashid, All United Arab Emirates.
